-40%

NAD MONITOR SERIES STEREO PREAMPLIFIER Model 1300. Re-Capped amd Working NICELY

$ 198

Availability: 57 in stock
  • Type: Pre-Amp
  • All returns accepted: ReturnsNotAccepted
  • Condition: Great Shape, Please Read work done below. Don't settle for one that "works" The caps go bad in these over time. Search AudioKarma with model number and read. Has a couple scuffs on top lid, pretty typical. MM and MC Carts can be used on this unit.
  • Brand: NAD
  • Number of Channels: 2
  • Model: NAD 1300 Monitor Series

    Description

    NAD MONITOR SERIES STEREO PREAMPLIFIER Model 1300. Made around 1987.
    This unit has been Re-Capped, meaning All the electrolytic capacitors have been replaced with New Audio Grade Elna Silmic II and Nichicon Capacitors. The original caps were YEC, a fairly low cost capacitor of the 80's and all 34+ years old with tolerances that have wandered out of spec.
    Also, all suspect and bad soldered joints were touched up and re-soldered where needed. In addition, I cleaned all the control pots and switches with De-Oxit D5 and De-oxit Fader lube for noise free operation of all controls. Did a casual cleanup of the front knobs and tested unit and all inputs including PHONO, CD, Video, Tuner and Tape loop. All are operating nicely. Unit is in Great Shape only a couple of scuffs on top side, pretty typical for its age. All knobs, lever caps and Feet are all original and present.
    Note this unit has a couple of switches on the back for different PHONO setup for use with MM (Moving Magnet) and MC (Moving Coil) which basically are different types of cartridges found in various table types.
    Shipping will be well packed and use FedEx Ground service.
    Please email with any questions.
    Take Care
    Specs from the Vintage Knob;
    PHONO section
    Input impedance :47
    kOhm
    / 200pF
    (MM)
    100 Ohm / 1000pF
    (MC)
    Input sensitivity :1,3
    mV
    (1
    Khz
    , 0,5
    V
    ref.)
    60µV
    (1
    Khz
    , 0,5
    V
    ref.)
    MM input overload :20
    mV
    (20
    Hz
    )
    200
    mV
    (1
    Khz
    )
    2000
    mV
    (20
    Khz
    )
    MC input overload :10
    mV
    (20
    Hz
    )
    10
    mV
    (1
    Khz
    )
    100
    mV
    (20
    Khz
    )
    S/N
    ratio :80
    dB
    (MM, 0,5
    V
    ref.)
    78
    dB
    (MC, 0,5
    V
    ref.)
    THD :< 0,02%
    (20
    Hz
    ...20
    Khz
    )
    RIAA accuracy :± 0,3
    dB
    (20
    Hz
    ...20
    Khz
    )
    LINE section
    Input impedance :100
    kOhm
    / 220pFInput sensitivity :80
    mV
    (0,5
    V
    ref.)
    Maximum input signal :12
    V
    S/N
    ratio :> 100
    dB
    (IHF-A ; 0,5
    V
    ref.)
    Frequency response :± 0,3
    dB
    preamp outputs :50 Ohm
    (normal)
    100 Ohm
    (high)
    tape outputs :1
    kOhm
    headphones :70 OhmMaximum output level :12
    V
    (tape & normal)
    15
    V
    (high & headphones)
    TONE section
    Bass control :± 12
    dB
    at 50
    Hz
    or 120
    Hz
    or 250
    Hz
    Treble control :± 12
    dB
    at 3
    Khz
    or 6
    Khz
    or 12
    Khz
    Bass EQ :+ 3
    dB
    at 55
    Hz
    + 6
    dB
    at 36
    Hz
    Infrasonic filter :- 3
    dB
    at 14
    Hz
    (18
    dB
    /octave)
    General
    PC :20WDimensions :43,5 x 8,4 x 27,3
    cm
    Weight :5
    kg
    .List price :498$
    (august 1987)
    Optional :rack handles with red or black inserts
    (red strongly recommended)